As a highlight, we offer a high-tech hinge for our Sport and Touring seats for the Vespa P-Series, Largeframe Oldie and Vespa T5. This functional component replaces the standard fastening system, optimizing handling while also serving as a stylish eye-catcher for your Vespa scooter.
All our hinges are 100% made in Germany.
Properties:
- Suitable for Vespa P-series, Largeframe Oldie and T5
- Made of high-strength stainless steel
- Base price: 99 € including all necessary fastening materials, installation instructions and new cover plate
- The hinge is delivered as a kit
Please note that with the front hinge, the seat can no longer be locked.
Price hinge upgrade (description of versions: see below):
- Hinge for seats of version 3.0: 99 €
- Hinge for seats of version 2.0: 99 €
- Hinge for seats of version 1.0: € 99 plus 19 € for a new rivet sheet (V3.0)
The initial seats from early to mid-2014 did not yet have fixed press-fit threaded bolts installed in the rivet plate under the seating surface.
Furthermore, the layout of the spacer sleeves was different. The hinges therefore only fit on the new rivet plate with the press-fit threaded bolts.
Therefore, please check beforehand which type of seat respectively version is involved!
Instruction: Remove the bumpers, screws, and cover plate. Then, verify if the spacer sleeves can be loosened to reveal a press-fit threaded bolt underneath (versions 2.0 and 3.0).
V1.0 is equipeed with standard M6 bolts.
With version 1.0, large washers are still installed underneath the spacer sleeves.
Version differences Largeframe seats:
Version 3.0 (from around the start of 2017)
- Thicker upholstery
- Ventilation holes in the seat body
- Brushed stainless steel cover plate without engraved logo
- A total of 6 built-in buffers: 2 small ones at the front, 2 larger ones in the centre and 2 larger ones at the rear
- Short lock with 16 mm cylinder length
Version 2.0 (from around mid-2014 to early 2017)
- Aluminium cover plate (some with engraved logo)
- One small buffer at the front and 4 large ones at the back and in the centre
- Long lock with 40 mm cylinder length
- Repkit partially installed (black half-moon wedge and bent stainless steel plate in the tip)
- Spacer sleeves are fastened with normal M6 washers and spring washers (see photo)
Version 1.0 ( from the beginning of 2014 until approx. mid-2014)
- Aluminium cover plate (some with engraved logo)
- One small buffer at the front and 4 large ones at the back and in the centre
- Long lock with 40 mm cylinder length
- Spacer sleeves are fastened with screws and large washers (see photo)
V 1.0 = Large washers under the spacer sleeves
